TRIDONIC LCI 15 W 700 mA IP20 Power Supply (TEC series) – Compact Fixed Output LED Driver

TRIDONIC constant current LED driver from the TEC series with an output current of 700 mA and a power of 15 W. Universal power supply range 120–240 V AC/DC, high efficiency >80%, thermal and overload protection, protection class II (SELV), IP20 housing. Model according to data sheet: LCI 015/0700 E020, item no. 24166313.

Key Features

• Constant output current: 700 mA (tolerance ±8%), power up to 15 W.
• Universal power supply: 120–240 V AC (50/60 Hz) / DC; PF > 0.95 (230 V/50 Hz).
• High efficiency: > 80%; Quick start ? 0.5 s.
• Protection: overheating, overload (auto-restart), short circuit (shutdown + auto-restart).
• Protection class: II, SELV; IP20.
• Cable entry/strain relief: strain relief;
• Screw connections.

Electrical and operating data

• Rated supply voltage: 120–240 V; AC range: 108–264 V; DC range: 120–240 V.
• Maximum power consumption: 17 W; mains current (230 V/50 Hz): 0.08 A.
• Output voltage range: 10–21.5 V; max. no-load voltage: 48 V.
• Output current ripple: ±35%; repetitive/non-repetitive peak current: 1020/1150 mA.
• Backup time during power failure: 10 ms.
• Ambient temperature (ta): -25…+50 °C (for 50,000 h: up to +40 °C); tc max.: 70 °C.
• Lifespan up to: 50,000 h; glow threshold: 850 °C (EN 60695-2-11).

Dimensions and installation

• Dimensions (LxWxH): 165 × 43 × 30 mm; hole spacing: 142 mm.
• Cables: input 0.5–1.5 mm2, output 1.0–2.5 mm2; stripping length: 7.5–8.5 mm.
• Max. LED cable length: 2 m; recommended distance between power cables and LED cables: 5–10 cm.
• Maximum mounting torque: 0.5 Nm (M4).

Compliance and standards

• Standards: EN 55015, EN 61000-3-2, EN 61000-3-3, EN 61347-1, EN 61347-2-13, EN 61547, EN 62384.
• Installation class: Class II device; In Class I luminaires, additional measures are required (according to the manufacturer's guidelines).

Installation / Safety Instructions

• Do not connect/disconnect LED modules on the secondary side (SEC).
• If the output voltage is exceeded, automatic shutdown occurs and restart occurs after the cause is removed.
• Protect cables from ground short circuits/sharp edges; keep them as short as possible to reduce EMI.
• Insulation strength tests in luminaires should be performed in accordance with IEC 60598-1 Annex Q (500 V DC/1 s).